Fibre Transmission Systems


HDMI Extension over single fiber with opticalCON connector

The system uses advanced high speed multiplex architecture for the combination of 3 RGB, 1 clock  and the DDC bus into a single data stream with a back channel using WDM technology.

Two data streams travel at the same time at different light wavelength making it possible to use only one wire. Both EDID and HDCP information are transparently carried in this system over 400m/1000ft over a single fiber.

The Fiberone-Pro Net is unique in its design using Silicon Image TX and RX chips that have powerful Eqs und Re-clockers built in avoiding typical problems of standard fiber transmitters that increase jitter to a rate where displays go out of sync. The unit has DVI connectors for reliability but is a full HDMI 1.3 transmission system including HDCP. Using a simple HDMI to DVI Adaptor cable is all you need to even transmit 3D content. In addition to the HDMI/DVI Video signal one stereo audio channel and one RX-232 channel may be transmitted simultanuously.

No Copper technology
The transmission of DDC bus data over fiber is avoiding typical problems that can occur with hybrid fiber extenders that use fiber for high speed data and copper for the DDC bus. These more "simple" designs can suffer from too high capacitance of the copper wires that transmit EDID and HDCP data. Unfortunately we have reports that this  already can happen with 15m/33ft of cable length. If this ancillary data is corrupted the high quality fiber transmission of picture data is worthless as it cannot be decrypted. Fiberone-Pro Net is using all fiber transmission!

Integrated Transmission of 10/100BaseT Signals
The Fiberone-Pro Net is using the second fiber of the opcialCON cable to transmit Ethernet 10 or 100BaseT signals. This allows the user to run the video signal along with the LAN control over one fiber cable for easiest setup in any configuration.

  •  HDMI 1.3 compatible
  • Integrated transmission of 10/100BaseT
  • Re-clocker and Equalizer in TX and RX unit
  • opticalCON DUAL socket
  • opticalCON accepts standard LC connectors
  • up to 400m/1000 ft distance
  • Uncompromised transmission of EDID and HDCP
  • fully decoupling of transmitter and receiver
  • accepts all PC and HD resolutions
  • 1080p , WUXGA and 2k x 1k compatible
  • RS-232 transmission bidirectional up to 115 k baud
  • Stereo Audio forward transmision
  • internal power supply 110V - 250V
  • Neutrik powerCON mains connection
  • 19 inch rack mount included

Order Numbers


For Requests

Beratung / Consulting
Beratung / Consulting

Sales Services
Tel. 044 736 50 10